|
|
|
Telephone Bridged 4 Lines to
6 Lines |
|
 |
47609-0F6
1 x 4 (6-Line)
Bridged Telephone Expansion Board |
|
Telephone Module |
|
|
47689-00B 47603-110
Click picture to enlarge
|
47689-00B
1 x 9 Bridged telephone module with Back bracket
47603-110
1 x 9 Bridged telephone module - No Back Bracket
Bridge up to four (4) telephone lines through to nine outlet locations, and
operate up to nine separate telephones from this easy-to-use 110 style
module. The module with printed circuit board, is constructed with ten
bridged 4-pair 110 type insulation displacement connections and is
suitable for phone, fax or modem.
|
|
Bridged Telephone Security Module |
|
 |
47609-TSV
1 x 7 Telephone Security Module, with Mounting Bracket. |
|
Click picture to enlarge |
47609-S10
1 x 10 Bridged telephone Security board. No Back Bracket. Eleven Bridged
6-Pair 110-IDC, 1 RJ455.75 " High
x 3.50" Wide x 0.63" Deep |
|
Data and Voice Module |
|
47605-C5B
47603-OC5
Click picture to enlarge |
47605-C5B
6 Port Cat 5e Voice and Data Module
with Mounting Bracket
47603-0C5
Without Mounting Bracket just the expansion
board.
Use Unshielded Twisted pair cable (UTP) to route
data, phone, fax or modem signals. Connect with patch cords to the Decora
Media System Hub, the Telephone Distribution Module in Levition's
Pre-Configured Structured Cabling Panels, a key system or a network hub.
This printed circuit board module with six Category 5e ports meets FCC par
68 and TIA/EIA standards. |
|
DSL Filter |
|
47616-DSB 47616-DSF
Click picture to enlarge
|
47616-DSB
DSL Filter Module with Mounting Bracket
47616-DSF
DSL Filter Module without Bracket
Use Leviton's whole-house DSL Filter Expansion
Board or DSL Filter Stand-alone Module to filter the DSL signal from any
4-pair telephone line before distribution throughout the home or office.
This eliminates the need to install DSL filters at each
wallplate. For use with Leviton’s Structured Media™ System.
|
To be installed
inside a listed demarcation device only, by qualified service personnel
who are those that have the knowledge, training, and or certification(s)
sufficient to understanding the requirement for installing and servicing
the equipment and comply with all local/regional/national codes.
|
