Wall speaker ceiling speaker prewire kit EZ Cap system for installation
of speaker wire for builders and home remodelers and home renovation put it in
before the walls go on using the EZcap system. EZCap wall speaker ceiling
speaker prewire kit installation for pre-wiring home theater system for
builders and installers, home renovators and home construction. EZCap home
wall speaker and ceiling speaker prewire installation
is made simple for future wiring by using the EZCap system. Place in the wall
before you close the wall up and rund your speaker wire through the EZCap
speaker installation home theater system kit hole. Sheet rock the wall and cover
the hole with the EZCap cover. Later when you want to install your speaker
system just open the cap cover and your wire is there inside the EZCap hole.
Leave the wall neat if you not ready to install the speakers yet. Use the EZCap
construction kit and cover and forget it until your ready later.
Once
you know where you are going to place your speakers and the speaker
wires then you know where you can place the EZCap. Fasten the long
flat installation bar between the studs and your ready to go. The
round EZCap hole should be left flush with the sheet rock. You can
place the cover over the EZCap hole to seal it up after the sheet
rock is placed. This will conceal the hole neatly for some future
time that you wish to actually install the speaker.
Later when your ready to put in your speakers, draw you outline for
the speaker using the speaker template that comes with your speaker
system centering it to where you EZCap wire will be coming through.
Placed
the cap over the finished wall for later access to the speaker
wires.
Wall speaker ceiling speaker prewire kit EZ Cap system for installation
of speaker wire for builders and home remodelers and home renovation put it in
before the walls go on using the EZcap system. EZCap wall speaker ceiling
speaker prewire kit installation for pre-wiring home theater system for
builders and installers, home renovators and home construction. EZCap home
wall speaker and ceiling speaker prewire installation
is made simple for future wiring by using the EZCap system. Place in the wall
before you close the wall up and rund your speaker wire through the EZCap
speaker installation home theater system kit hole. Sheet rock the wall and cover
the hole with the EZCap cover. Later when you want to install your speaker
system just open the cap cover and your wire is there inside the EZCap hole.
Leave the wall neat if you not ready to install the speakers yet. Use the EZCap
construction kit and cover and forget it until your ready later.
Once
you know where you are going to place your speakers and the speaker
wires then you know where you can place the EZCap. Fasten the long
flat installation bar between the studs and your ready to go. The
round EZCap hole should be left flush with the sheet rock. You can
place the cover over the EZCap hole to seal it up after the sheet
rock is placed. This will conceal the hole neatly for some future
time that you wish to actually install the speaker.
Placed
the cap over the finished wall for later access to the speaker
wires.
