Insert Modules Leviton structured media

Leviton module choices for inserting into structured media panels from basic video and data to 24 port data modules video splitter and amplifiers if you don't see it email us.

● Audio Video Leviton
● Audio Video PepX
● Banana Plug Leviton
● Banana Plug PepX
● Cable Ties
● Camera Outdoor Leviton
● Catv Voice Jack PepX
● Jacks connectors Leviton
   Decora Jacks
   Cat5 - Cat6
   Shielded
● Jacks connectors PepX
● F Connector Leviton
● F Connector PepX
● Fiber Optic Connector
● Fiber Optic Panels
● HDMI- Home Theater
● Media Panels Leviton
● Media Panels PepX
● 25 Pair Telco Panel
● Panel 12 Port Pop In
● Patch Panels Leviton
● Patch Panels PepX
   12 port to 96 port
   Cat 6 panels
  Patch cords
   10G Patch Cords
   Shielded cords
● Mini Patch Panels
   25 Pair
● Patch Cable Leviton
● Patch Cable PepX
● Phone-Voice
● 66 Block Leviton
● 66 Block PepX
● 110 Punch Blocks
● Phone plug adapters
   Test Set
● RJ Male Plugs PepX
● Rack Management
   Versi Duct
● Raceway for Cable
● Routers
● Shielded Hardware
● Surround Sound PepX
   Wall Plate Speaker
● Security Access PepX
● Surface Box Leviton
● Surface Box PepX
   Voice Phone
   Wall Phone Jack
   Beanie Connector
● Tools Testers
● Token Ring PepX
● Video distribution Lev
● Video Splitter PepX
● Video Intercom
● Wall Plates Leviton
● Wall Plates PepX
● Wall Plate Jack Combo
● Wall Mount Brackets
● Wireless Access
● Z Blocker PepX

47609-0F6 47689-00B 47603-110 47609-TSV 47609-S10 47605-C5B 47603-0C5 47616-DSB 47616-DSF


Telephone Bridged 4 Lines to 6 Lines
	47609-0F6 1 x 4 (6-Line) Bridged Telephone Expansion Board
Telephone Module
47689-00B 47603-110 Click picture to enlarge	47689-00B 1 x 9 Bridged telephone module with Back bracket 47603-110 1 x 9 Bridged telephone module - No Back Bracket Bridge up to four (4) telephone lines through to nine outlet locations, and operate up to nine separate telephones from this easy-to-use 110 style module. The module with printed circuit board, is constructed with ten bridged 4-pair 110 type insulation displacement connections and is suitable for phone, fax or modem.
Bridged Telephone Security Module
	47609-TSV 1 x 7 Telephone Security Module, with Mounting Bracket.
Click picture to enlarge	47609-S10 1 x 10 Bridged telephone Security board. No Back Bracket. Eleven Bridged 6-Pair 110-IDC, 1 RJ45 5.75 " High x 3.50" Wide x 0.63" Deep
Data and Voice Module
47605-C5B 47603-OC5 Click picture to enlarge	47605-C5B 6 Port Cat 5e Voice and Data Module with Mounting Bracket 47603-0C5 Without Mounting Bracket just the expansion board. Use Unshielded Twisted pair cable (UTP) to route data, phone, fax or modem signals. Connect with patch cords to the Decora Media System Hub, the Telephone Distribution Module in Levition's Pre-Configured Structured Cabling Panels, a key system or a network hub. This printed circuit board module with six Category 5e ports meets FCC par 68 and TIA/EIA standards.
DSL Filter
47616-DSB 47616-DSF Click picture to enlarge	47616-DSB DSL Filter Module with Mounting Bracket 47616-DSF DSL Filter Module without Bracket Use Leviton's whole-house DSL Filter Expansion Board or DSL Filter Stand-alone Module to filter the DSL signal from any 4-pair telephone line before distribution throughout the home or office. This eliminates the need to install DSL filters at each wallplate. For use with Leviton’s Structured Media™ System.
To be installed inside a listed demarcation device only, by qualified service personnel who are those that have the knowledge, training, and or certification(s) sufficient to understanding the requirement for installing and servicing the equipment and comply with all local/regional/national codes.

Don't mix and match - you should be a qualified installer and know what you are ordering before you order, you are responsible for proper installation and use of any item ordered.
© Copyright 1998, All rights reserved.

03/08/2009